Esthetics

Ambar

Adhesive system for enamel and dentin

2-step conventional adhesive: primer and bond in the same bottle;
Light-curing.

Advantages

Higher Adhesive Potential: The presence of MDP in the composition makes a chemical bond with the dental structure, which adds mechanical adhesion, giving the product a superior adhesive strength.

Higher stability and resistance to adhesive film: Due to the presence of treated silica nanoparticles.

Quality of the polymerization: Its chemical characteristics guarantee the quality of the polymerization (even in high moisture environment) and consequent longevity of the adhesive film.

Indications

• All classes of direct restorations with composites (classes I, II, III, IV and V) and photo-curable
ionomeric cements.
• Adhesive cementation (together with resinous cement) of prosthetic parts (intracanal posts /
cores, crowns, onlays / inlays and veneers) in fiberglass, ceramics, composite and metal.
• Adhesive repairs in ceramics and composites.

Step by step

1

The surface to be restored shall be cleaned and then etched with phosphoric acid at 37% Condac 37 (FGM) for 15 seconds (same time for enamel and dentin). It is important to isolate the tooth, whether with complete isolation or relative (depending on the case).

2

Rinse the surface with plenty of water and dry the cavity until it is wet, not dehydrated.

3

With a micro applicator Cavibrush (FGM), the adhesive is applied rubbing the first drop of the product for 10 seconds. Next, a new layer of adhesive is applied to the same surface for 10 more seconds.

4

Apply an air jet for 10 seconds, which helps to evaporate the solvent, and consequently to increase adhesion.

5

The adhesive shall be light-cured for 10 seconds, then perform restoration. Note: for intra canal adhesive application, the photoactivation time shall be extended to 20 seconds.